Product Description
This is an unmarked motorized translation stage. The table surface is 4.5 inches square and has a range of motion 6 x 6 inches. The baseplate is 12 x 7 inches (with an additional 5 inches required by the motor and coupling housings. The motor housing drops approximately 0.625 inches beneath the level of the base, so a riser plate would be needed if this were to be mounted on a large flat surface. The cross-motion stage is somewhat smaller, at 12 by 4.5 inches (again, with an additional 5 inches required for the motor and coupling). Height of the table from the bottom plate (excluding motor housing) is 3.00 inches.
Both motions are imparted by precision ball-screws with a 4mm pitch. On either side of the ball screw nut are paired recirculating bearing cages to eliminate any ptich wobble.
The motors are Superior Electric Slo-Syn synchronous stepping type, with 200 steps per revolution (0.02mm/step). Motor type number is M062-FD09. There are no connectors on the motors – the leads on one motor are about 4 inches long, on the other motor closer to 10 inches. There are also limit switches for either end of the excursion for both X and Y axes, however, they are not connected to anything presently.
The stage is in excellent condition and very nicely made.
Location H2R5
Photo set 765